Qx'o^,.t l""tt n" - LLILI /a*z-g
TOU/MC/DAUIil|25l lO
DO NOT OPEN THIS TEST BOOKLET UNTIL YOU ARE ASKED TO DO SO
Test Booklet No. :
00763
Tlnc Altowod 3 2 Hours
TEST BOOKLET
MECHANICAL ENGINEERING
Series
trull Marks : lOO
Raqd the JoUout tg ln ttucLto, ca,!/ltLg bafor. gou hegln to a;ntw.r thc qlottlon I
1, The name of the Subject, RoU Number as mentioned iu the Admission Certilicate, Test Booklet No. and Series
are to be qtritten legibly and correcUy in the space provided on the Answer-Sheet with Black/Blue balpoint pen.
2. Anwor-ShGct wlthout Brrldng SctlGs a! metrtloaGd abovo ln the spece provldod for ln the AlrEwcr-ShoGt
lhdl trot b. .vrlustod.
3. All questiona carry equal marks.
fhc Anlwcr-Shcct lhou.ld be lubDtttsd to tho Invlgllrtor.
Diredions for giving the 4nsure,.s : Directions for €nswering questions have already been issued to tlle respective
candidatcs in the 'Instructions for marking in the OMR Answer-Sheet' along with the Admit Card and Specimen
Copy of the OMR Arlswer-Sheet.
E cdfiple :
Suppose the followilg question is asked :
T1!e capital of Bargladesh is
(Al Chennai
(B) London
(C) Dhaka
(D) Dhubri
You will have four altemauves it! the Answer-Sheet for your response corresponding to each question of the
Test Booklet as belorp :
@@o@In the above illustration, ifyour chos€n lesponse is alternative (C), i.e., Dhaka, tien the same should be marked
on the Answer-Sheet by blackening the relevant circle urith a Black/Blue balpoint pen only as below :
Tha .xsmplo rhosn .bovo t. tho only "r9*,q"*qa9qa!wodnr.4. Use of eraser, blade, chemical whitener Iluid to recti.& any response is prohibited.
5. Please ensure that the Test Booklet has the lequired number ofpages (16) and 1oO questions immediately after
opening tlle Booklet. [n case of any discrepancy, please report the same to the Invigilator.
6. No candidate thall be admitted to the Examination Hatl/Room 2O minutes after the commencement ol the
examination.
7' No ca.ndidate sha.U leave the Exg4lilgEgLIg!3gggwithout prior permission of tie Supervisor/Invigilato!, No
@swer-shiet and leave the Examin;tion HilTnoo- b"for"
expiry of the fuU tirne allotted for each paper.
8. No Mobile Phone, Electronic Communication Device, etc., are allowed to be carried inside ttte Examinatioo
HaI/Room by the candidates. Any Mobile Phone, Electronic Comaunication Device, etc., found in possession
of the candidate inside the Examination Hall/Room, even if on otrmode, shall be liable for conliscation.
9. No candidate shall have in his/her possession inside the Examination Hall/Room any book, notebook or loose
paper, except his/her Admission Certificate and other connected papers permitted by the Commission,
10. Complete silence must be observed in ihe Examination Hall/Room. No candidate shall copy from the paper of
ary otler candidate, or per6it his/her own paper to be copied, or give, or attempt to give, oi obtain, or attempt
to obtain imegulai assistance of any kind.
11. This Test Booklet can be caried with you after answering the questions in the prescribed Answer-Sheet,
12. Noncompliance with arry of the above instructions will render a candidate Uabte to penalty as may be deemed
ft.
13. No rough work is to be done on the OMR Answer-Sheet. You can do the rough work on tie space provided in tie
Test Booklet,
N.B. r Thcrc trlll bc rrcg.tlve t'r.rLltig @ o.25 per 1 (or'e) tllarla agaltrat each r.rotrg arrswcl.
/38-A I No. of Questlons : lOO ]
TOU/MC/DAUIil|25l lO
DO NOT OPEN THIS TEST BOOKLET UNTIL YOU ARE ASKED TO DO SO
Test Booklet No. :
00763
Tlnc Altowod 3 2 Hours
TEST BOOKLET
MECHANICAL ENGINEERING
Series
trull Marks : lOO
Raqd the JoUout tg ln ttucLto, ca,!/ltLg bafor. gou hegln to a;ntw.r thc qlottlon I
1, The name of the Subject, RoU Number as mentioned iu the Admission Certilicate, Test Booklet No. and Series
are to be qtritten legibly and correcUy in the space provided on the Answer-Sheet with Black/Blue balpoint pen.
2. Anwor-ShGct wlthout Brrldng SctlGs a! metrtloaGd abovo ln the spece provldod for ln the AlrEwcr-ShoGt
lhdl trot b. .vrlustod.
3. All questiona carry equal marks.
fhc Anlwcr-Shcct lhou.ld be lubDtttsd to tho Invlgllrtor.
Diredions for giving the 4nsure,.s : Directions for €nswering questions have already been issued to tlle respective
candidatcs in the 'Instructions for marking in the OMR Answer-Sheet' along with the Admit Card and Specimen
Copy of the OMR Arlswer-Sheet.
E cdfiple :
Suppose the followilg question is asked :
T1!e capital of Bargladesh is
(Al Chennai
(B) London
(C) Dhaka
(D) Dhubri
You will have four altemauves it! the Answer-Sheet for your response corresponding to each question of the
Test Booklet as belorp :
@@o@In the above illustration, ifyour chos€n lesponse is alternative (C), i.e., Dhaka, tien the same should be marked
on the Answer-Sheet by blackening the relevant circle urith a Black/Blue balpoint pen only as below :
Tha .xsmplo rhosn .bovo t. tho only "r9*,q"*qa9qa!wodnr.4. Use of eraser, blade, chemical whitener Iluid to recti.& any response is prohibited.
5. Please ensure that the Test Booklet has the lequired number ofpages (16) and 1oO questions immediately after
opening tlle Booklet. [n case of any discrepancy, please report the same to the Invigilator.
6. No candidate thall be admitted to the Examination Hatl/Room 2O minutes after the commencement ol the
examination.
7' No ca.ndidate sha.U leave the Exg4lilgEgLIg!3gggwithout prior permission of tie Supervisor/Invigilato!, No
@swer-shiet and leave the Examin;tion HilTnoo- b"for"
expiry of the fuU tirne allotted for each paper.
8. No Mobile Phone, Electronic Communication Device, etc., are allowed to be carried inside ttte Examinatioo
HaI/Room by the candidates. Any Mobile Phone, Electronic Comaunication Device, etc., found in possession
of the candidate inside the Examination Hall/Room, even if on otrmode, shall be liable for conliscation.
9. No candidate shall have in his/her possession inside the Examination Hall/Room any book, notebook or loose
paper, except his/her Admission Certificate and other connected papers permitted by the Commission,
10. Complete silence must be observed in ihe Examination Hall/Room. No candidate shall copy from the paper of
ary otler candidate, or per6it his/her own paper to be copied, or give, or attempt to give, oi obtain, or attempt
to obtain imegulai assistance of any kind.
11. This Test Booklet can be caried with you after answering the questions in the prescribed Answer-Sheet,
12. Noncompliance with arry of the above instructions will render a candidate Uabte to penalty as may be deemed
ft.
13. No rough work is to be done on the OMR Answer-Sheet. You can do the rough work on tie space provided in tie
Test Booklet,
N.B. r Thcrc trlll bc rrcg.tlve t'r.rLltig @ o.25 per 1 (or'e) tllarla agaltrat each r.rotrg arrswcl.
/38-A I No. of Questlons : lOO ]
According to the principle of
transmissibility of forces, the effect
of a force upon a body is
(A) maximum when it acts at the
centre of $avity of the body
(B) same at every point in its line of
action
(C) minimum when it acts at the
centre of gravity of the body
(D) different at different points in
its line of action
The unit of 'work' in SI is given by
(4 watt (B) joule
(C) newton (D) dyne
The forces, which meet at one point,
but their lines of action do not lie in
a plane, are known as
(A) intersectingforces
(B) non-coplanar concurrent forces
(C) coplanar non-concurrent forces
(D) non-coplanar non-concurrent
forces
In a statically determinate plane
truss, the number of joints (j) and
the number of members (rd) are
related by
(A) j =2m-3
(B) m=2j +r
(C) m=2j -3
(Dl m=2j -1
TOU/ MC/ DAUH l2s I 10 lse-A
The coefficient of restitution of a
perfectly plastic impact is
(A) 0 (B) 1
(cl 2 (D) @
The product of either force of a
couple with the arm of the couple is
called
(A} moment of the couple
(B) moment of the forces
(C) resultant couple
(D) None of the above
The V-belt standard groove angle
falls in which of the following?
(A) 50' to 65"
(B) 20' to 30"
(C) 35' to 40"
(D) r5' to 20'
Coulomb friction is the other name
of
(A) fluid friction
(B) drag
(c) lift
(D) dry friction
In virtual work principle, the work
done by self-weight of a body is
taken into consideration r hen
(A) centre of gravity moves
verticallY
(B) centre of graviry moves
horizontally
(C) shear force moves horizontally
(D) shear force moves vertically
5.
7.
8.
2
transmissibility of forces, the effect
of a force upon a body is
(A) maximum when it acts at the
centre of $avity of the body
(B) same at every point in its line of
action
(C) minimum when it acts at the
centre of gravity of the body
(D) different at different points in
its line of action
The unit of 'work' in SI is given by
(4 watt (B) joule
(C) newton (D) dyne
The forces, which meet at one point,
but their lines of action do not lie in
a plane, are known as
(A) intersectingforces
(B) non-coplanar concurrent forces
(C) coplanar non-concurrent forces
(D) non-coplanar non-concurrent
forces
In a statically determinate plane
truss, the number of joints (j) and
the number of members (rd) are
related by
(A) j =2m-3
(B) m=2j +r
(C) m=2j -3
(Dl m=2j -1
TOU/ MC/ DAUH l2s I 10 lse-A
The coefficient of restitution of a
perfectly plastic impact is
(A) 0 (B) 1
(cl 2 (D) @
The product of either force of a
couple with the arm of the couple is
called
(A} moment of the couple
(B) moment of the forces
(C) resultant couple
(D) None of the above
The V-belt standard groove angle
falls in which of the following?
(A) 50' to 65"
(B) 20' to 30"
(C) 35' to 40"
(D) r5' to 20'
Coulomb friction is the other name
of
(A) fluid friction
(B) drag
(c) lift
(D) dry friction
In virtual work principle, the work
done by self-weight of a body is
taken into consideration r hen
(A) centre of gravity moves
verticallY
(B) centre of graviry moves
horizontally
(C) shear force moves horizontally
(D) shear force moves vertically
5.
7.
8.
2